Liberty Hardware - Cup Pulls II - 2 1/2" & 3" Centers Dual Mount Cup Pull in Antique Copper

Q&A

1. Q: Don’t understand the reply to the 2nd question about 2 ½ and 3” centers . . . The cup pull is meant to attach via a single hole, yes?
   A: The cup pulls attach with two screws on the drawer front.  This particular cup pull has two sets of mounting holes to accommodate both 2 1/2" and 3" pre-existing centers.  Was this answer useful to you? Yes (0) No (0) Yes (0) No (0)
2. Q: If I was using to replace a 3.5" boring, would the pull cover the old hole?
   A: The cup pull can be used to cover your existing holes since the overall length is 4 1/8” inch so that new standard holes may be drilled.  Was this answer useful to you? Yes (0) No (0) Yes (0) No (0)
3. Q: Do they make cabinet hinges in the matching color?
   A: Liberty hardware does not offer a coordinating hinge.  However a similar copper finish hinge from an alternate manufacturer would match well.  Was this answer useful to you? Yes (0) No (0) Yes (0) No (0)
4. Q: Item LIB-30149, the description states 2 1/3 and 3" centers but the item no. does not specifiy which applies.
   A: This particular cup pull has two sets of mounting holes to accommodate both 2 1/2" and 3" pre-existing centers.  Was this answer useful to you? Yes (3) No (1) Yes (3) No (1)
5. Q: Do you have knobs and finger pulls to match?
   A: Please be advised the coordinating knob to this particular cup pull is Item # LIB-30127. Was this answer useful to you? Yes (1) No (0) Yes (1) No (0)